I am testing a wizard that Robert Adams is doing for threading with Linuxcnc. There are problems with the Gcode but I am not clued up enough to help. Below is the code that is generated but it does not execute. It runs to G76 and then it just waits there. I think the I and K values are swapped and the I must be negative for outside thread but cannot tell anything more.
G18 G90 G7 G21 G94 G97 S828 M3 T3 M6 M8 F401.1 G0 Z2.54 G0 X8.635 G76 P1.25 Z-15 I0.635 J0.2 K1.083 Q0 H0 L2 E1.083 M9 M5 M30 ----------------------------- Regards / Groete Marius D. Liebenberg +27 82 698 3251 +27 12 743 6064 ------------------------------------------------------------------------------ Monitor 25 network devices or servers for free with OpManager! OpManager is web-based network management software that monitors network devices and physical & virtual servers, alerts via email & sms for fault. Monitor 25 devices for free with no restriction. Download now http://ad.doubleclick.net/ddm/clk/292181274;119417398;o _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
