Any suggestions please gents?
>I am testing a wizard that Robert Adams is doing for threading with >Linuxcnc. There are problems with the Gcode but I am not clued up >enough >to help. Below is the code that is generated but it does not execute. >It >runs to G76 and then it just waits there. >I think the I and K values are swapped and the I must be negative for >outside thread but cannot tell anything more. > >G18 G90 G7 >G21 >G94 >G97 S828 M3 >T3 M6 >M8 >F401.1 >G0 Z2.54 >G0 X8.635 >G76 P1.25 Z-15 I0.635 J0.2 K1.083 Q0 H0 L2 E1.083 >M9 >M5 >M30 > > > >----------------------------- >Regards / Groete > >Marius D. Liebenberg >+27 82 698 3251 >+27 12 743 6064 >------------------------------------------------------------------------------ >Monitor 25 network devices or servers for free with OpManager! >OpManager is web-based network management software that monitors >network devices and physical & virtual servers, alerts via email & sms >for fault. Monitor 25 devices for free with no restriction. Download >now >http://ad.doubleclick.net/ddm/clk/292181274;119417398;o >_______________________________________________ >Emc-users mailing list >[email protected] >https://lists.sourceforge.net/lists/listinfo/emc-users ------------------------------------------------------------------------------ Monitor 25 network devices or servers for free with OpManager! OpManager is web-based network management software that monitors network devices and physical & virtual servers, alerts via email & sms for fault. Monitor 25 devices for free with no restriction. Download now http://ad.doubleclick.net/ddm/clk/292181274;119417398;o _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
