The VFD has been on that machine since the original conversion from Anilam to LinuxCNC. Hm2 has reported errors from time to time all along but never quit. Upgrading to 2.7 was the reason it now won't run when the VFD is plugged in due to a change in 2.7 that's a bit over reactive at this time. If I can get it to run even with the overly sensitive software then I'm good. I upgraded to 2.7 to use my new probe with an encoder input.
JT On 12/21/2015 10:54 AM, John Dammeyer wrote: > The addition of the VFD might just put an system that is on the edge of > being unstable over the edge. > John Dammeyer > > >> -----Original Message----- >> From: John Thornton [mailto:j...@gnipsel.com] >> Sent: December-21-15 3:15 AM >> To: Enhanced Machine Controller (EMC) >> Subject: Re: [Emc-users] Grounding Issues >> >> >> By robust, what do you mean? >> >> JT >> >> On 12/20/2015 6:44 PM, John Dammeyer wrote: >>> John, >>> I'd still take a close look at your existing system to see if it is > robust. >>> >> >> > ---------------------------------------------------------------------------- > -- >> _______________________________________________ >> Emc-users mailing list >> Emc-users@lists.sourceforge.net >> https://lists.sourceforge.net/lists/listinfo/emc-users > > ------------------------------------------------------------------------------ > _______________________________________________ > Emc-users mailing list > Emc-users@lists.sourceforge.net > https://lists.sourceforge.net/lists/listinfo/emc-users ------------------------------------------------------------------------------ _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users
