I've not played with EDM for quite a while. > 10 years so I've forgotten most of what I knew. I know of people that used hardware store lantern oil as EDM fluid. If it sounds like frying bacon you are in the right range. Sounds (npi) like fun. :-)
Dave On 06/19/2016 10:07 AM, Nicklas Karlsson wrote: >> On 06/19/16 17:55, Nicklas Karlsson wrote: >>> I tried to tune parameters manually but most of the time is spent either in >>> short circuit or open circuit, >> this is called 'hammering' >> it actually works but for a poor reason. >> if the tools is too far away, you are open >> if the tool is too close, it is shorting >> For a brief time in transit between these 2 states you DO achieve the >> proper position >> and you get _some_ sparks. >> >> the idea is to find the ideal position where sparks occur easily >> yiu can find this if you can control the 'edm servo'. > Then I now how it should look. I didn't expect something good with my Lego > prototype without proper tuning and to low ignition voltage at the first run. > >> ... > You provided exactly the information I needed, thanks! > > > Regards Nicklas Karlsson > > > ------------------------------------------------------------------------------ > What NetFlow Analyzer can do for you? Monitors network bandwidth and traffic > patterns at an interface-level. Reveals which users, apps, and protocols are > consuming the most bandwidth. Provides multi-vendor support for NetFlow, > J-Flow, sFlow and other flows. Make informed decisions using capacity planning > reports. http://sdm.link/zohomanageengine > > > _______________________________________________ > Emc-users mailing list > Emc-users@lists.sourceforge.net > https://lists.sourceforge.net/lists/listinfo/emc-users ------------------------------------------------------------------------------ Attend Shape: An AT&T Tech Expo July 15-16. Meet us at AT&T Park in San Francisco, CA to explore cutting-edge tech and listen to tech luminaries present their vision of the future. This family event has something for everyone, including kids. Get more information and register today. http://sdm.link/attshape _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users