On 10/11/2016 03:19 AM, linden wrote:
> hello all,
>
>       I need some help and suggestions on interfacing dmm dyn4 servo
> driver with Linuxcnc

http://www.dmm-tech.com/Dyn4_main.html

LinuxCNC has all the features you need for servo control built-in, you 
really just need a dumb motor driver, then let LinuxCNC do the rest 
(encoder feedback, PID, command output). I use Pico's PWM input motor 
amplifiers to run brushed servos. I believe there are equivalent setups 
for brushless motors. This way LinuxCNC and therefore _you_ get full 
oversight and control of the system.


-- 
Kirk Wallace
http://www.wallacecompany.com/machine_shop/
http://www.wallacecompany.com/E45/

------------------------------------------------------------------------------
Check out the vibrant tech community on one of the world's most 
engaging tech sites, SlashDot.org! http://sdm.link/slashdot
_______________________________________________
Emc-users mailing list
Emc-users@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/emc-users

Reply via email to