PWM/dir though the bob. (these amc drives instead of +/-10v take pwm/dir)
sam On 1/24/2017 11:08 AM, Mark Johnsen wrote: > Linuxcnc -> mesa 5i25 pwm -> Cheap Bob -> AMC drive -> Servo -> Encoder > -> mesa 5i25 encoder counter -> Linuxcnc > > I guess you're sending Step and Direction to the AMC Drive from the Cheap > BOB? Not a +-10Vdc signal? > > Mark > ------------------------------------------------------------------------------ > Check out the vibrant tech community on one of the world's most > engaging tech sites, SlashDot.org! http://sdm.link/slashdot > _______________________________________________ > Emc-users mailing list > Emc-users@lists.sourceforge.net > https://lists.sourceforge.net/lists/listinfo/emc-users > > ------------------------------------------------------------------------------ Check out the vibrant tech community on one of the world's most engaging tech sites, SlashDot.org! http://sdm.link/slashdot _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users
