I probably should correct that and resubmit it, yes? Thanks for reading it, hind-sight being 20/20 and all, I probably should have asked you to look it over before submitting it.
Joe ----- On Apr 6, 2017, at 11:12 AM, Sebastian Kuzminsky s...@highlab.com wrote: > On Thu, Apr 06, 2017 at 10:46:56AM -0500, Joe Hildreth wrote: >> Well, what a learning experience that was. Have the manpage written, >> forked the linuxcnc project, added my page, committed and signed, >> and done a pull request. (With some help from some folks on the devel >> IRC channel). At any rate, it shows up in the documentation for 2.7 >> and 2.8-pre so I am happy. Hopefully, I didn't butcher the manpage >> up too bad. > > It looks great, thanks! > > A nit-pick about the Description section: it seems to imply that > hal_manualtoolchange stops the spindle and pauses the program, but it's > actually Motion that does that, before asking hal_manualtoolchange to > change tools. > > > -- > Sebastian Kuzminsky ------------------------------------------------------------------------------ Check out the vibrant tech community on one of the world's most engaging tech sites, Slashdot.org! http://sdm.link/slashdot _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users
