Was gonna say that. Something's gotta be messed up to get that prob. Danny
---- Todd Zuercher <zuerc...@embarqmail.com> wrote: > Honestly we hardly ever have to clean our tools, but we don't mill much > pitchy wood, mostly hardwoods and MDF. For us if a tool is getting clogged > up, it is because it is too dull and is getting too hot, or the feed rate is > way to slow and it got too hot. Either way it usually ends up in the bin. > > ----- Original Message ----- > From: "craig" <cr...@facework.com> > To: emc-users@lists.sourceforge.net > Sent: Thursday, April 13, 2017 12:33:11 PM > Subject: [Emc-users] Cleaning Carbide Bits -plywood gue. > > What is the best way to clean plywood glues off small carbide router bits? > > I use small carbide bits to work wood and sometimes plywood. Mostly > smaller than 3mm(1/8 in) bits. > Sometimes plywood glue melts onto the bits. Cleaning them is a > problem. Suggestions? > > Craig > > ------------------------------------------------------------------------------ > Check out the vibrant tech community on one of the world's most > engaging tech sites, Slashdot.org! http://sdm.link/slashdot > _______________________________________________ > Emc-users mailing list > Emc-users@lists.sourceforge.net > https://lists.sourceforge.net/lists/listinfo/emc-users > > ------------------------------------------------------------------------------ > Check out the vibrant tech community on one of the world's most > engaging tech sites, Slashdot.org! http://sdm.link/slashdot > _______________________________________________ > Emc-users mailing list > Emc-users@lists.sourceforge.net > https://lists.sourceforge.net/lists/listinfo/emc-users ------------------------------------------------------------------------------ Check out the vibrant tech community on one of the world's most engaging tech sites, Slashdot.org! http://sdm.link/slashdot _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users