> > I lost axis 1 the y axis the "position-cmd" and can't figure out how it get > > from the gui to the axis. axis.1.free-pos-cmd, axis.1.motor-pos-cmd and > > axis.0.joint-pos-cmd are always zero while it works for the other axis XZA. > > That is very strange. > What happens if you give an MDI move in Y? Then examined again it actually works in MDI but not then jogging.
> What is the axis/joint scale for Y in the INI? Scale is the same as for the other axis. > Which LinuxCNC version? Version is 2.8.0~pre1 and I have modified with gladevcp panel. I also modified the stepper driver but it is the same for all axis and happen before driver is reached. ------------------------------------------------------------------------------ Check out the vibrant tech community on one of the world's most engaging tech sites, SlashDot.org! http://sdm.link/slashdot _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users
