Be very careful - these tools may not be the best you can buy. Don't stock up until you have had an opportunity to prove the tool.
On Thu, Jun 29, 2017 at 4:01 PM, Andrew <[email protected]> wrote: > 2017-06-29 23:42 GMT+03:00 andy pugh: > > > After a bit of URL mangling: > > https://www.aliexpress.com/item/Free-shipping-1pc-10mm- > > hrc45-D10-25-D10-75-R2-Carbide-4-Flutes-Corner- > > Rradius-End/32214260073.html > > > > Looks about right. I can wait. > > > > Interesing why they say HRC45. It's too little obviously. A carbide tool > should be HRC75-80. > > Must be just a seller knowing nothing about the item. > ------------------------------------------------------------ > ------------------ > Check out the vibrant tech community on one of the world's most > engaging tech sites, Slashdot.org! http://sdm.link/slashdot > _______________________________________________ > Emc-users mailing list > [email protected] > https://lists.sourceforge.net/lists/listinfo/emc-users > -- Addressee is the intended audience. If you are not the addressee then my consent is not given for you to read this email furthermore it is my wish you would close this without saving or reading, and cease and desist from saving or opening my private correspondence. Thank you for honoring my wish. ------------------------------------------------------------------------------ Check out the vibrant tech community on one of the world's most engaging tech sites, Slashdot.org! http://sdm.link/slashdot _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
