Hi Johan
You will have to provide a bit more detail in order to get assistance.
Please explain what you mean by "does not hold size at all"
Explain how:
1) you discovered the problem and
2) how you measured the result and
3) what you done to solve it thus far.
Also give details on the controller version and GUI that you use.
------ Original Message ------
From: "Johann Beukes" <beukes1...@gmail.com>
To: emc-users@lists.sourceforge.net
Sent: 2017-08-28 06:12:00
Subject: [Emc-users] (no subject)
Hi guys
I am struggeling alot with my lathe X axis. The machine does not hold
size
at all. I am using The Leadshine ESM-22430 motor and the DS808 drive.
The
Dirsetup is set at 2500, Dirhold 2500, Steplen 5000, Stepspace 5000 and
stepscale at -322. The ballscrew has a 2.5mm pitch and the steps per
rev
are set at 800.
Can anybody please give me some advice?
Thanks
------------------------------------------------------------------------------
Check out the vibrant tech community on one of the world's most
engaging tech sites, Slashdot.org! http://sdm.link/slashdot
_______________________________________________
Emc-users mailing list
Emc-users@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/emc-users
---
This email has been checked for viruses by Avast antivirus software.
https://www.avast.com/antivirus
------------------------------------------------------------------------------
Check out the vibrant tech community on one of the world's most
engaging tech sites, Slashdot.org! http://sdm.link/slashdot
_______________________________________________
Emc-users mailing list
Emc-users@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/emc-users
