My 860 drives gave me a very hard time early on.only much sifting through
the Chenglish did I realize the drive steps on the rise and fall. Requiring
1/2 the steps calculated

On Aug 27, 2017 11:12 PM, "Johann Beukes" <beukes1...@gmail.com> wrote:

> Hi guys
> I am struggeling alot with my lathe X axis. The machine does not hold size
> at all. I am using The Leadshine ESM-22430 motor and the DS808 drive. The
> Dirsetup is set at 2500, Dirhold 2500, Steplen 5000, Stepspace 5000 and
> stepscale at -322. The ballscrew has a 2.5mm pitch and the steps per rev
> are set at 800.
> Can anybody please give me some advice?
> Thanks
> ------------------------------------------------------------
> ------------------
> Check out the vibrant tech community on one of the world's most
> engaging tech sites, Slashdot.org! http://sdm.link/slashdot
> _______________________________________________
> Emc-users mailing list
> Emc-users@lists.sourceforge.net
> https://lists.sourceforge.net/lists/listinfo/emc-users
>
------------------------------------------------------------------------------
Check out the vibrant tech community on one of the world's most
engaging tech sites, Slashdot.org! http://sdm.link/slashdot
_______________________________________________
Emc-users mailing list
Emc-users@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/emc-users

Reply via email to