On Tuesday 17 October 2017 09:21:45 andy pugh wrote: > On 17 October 2017 at 14:17, Gene Heskett <ghesk...@shentel.net> wrote: > > I've forgotten where its at, but there is a list that will let you > > match the hdmi_group and hdmi_mode lines to your monitor. > > https://elinux.org/RPiconfig
>From that page, what advantage might this be, and will it brick the sd card? Bear in mind that piclone has never worked on my pi's because no two sd cards are exactly the same size, so the resultant clone is unreadable. I have rsync'd copies on rotating media attached, but the commands to make it boot from that media haven't set that bit in the SoC to make it happen. ============ Enable ARMv8 on RPi3B When running lscpu or cat /proc/cpuinfo the reported processor ist ARMv7. To tell the RPi3B to start in ARMv8-mode you have to add a new line to config.txt.[10] arm_control=0x200 ============ Can anyone elaborate on this? Thanks. Cheers, Gene Heskett -- "There are four boxes to be used in defense of liberty: soap, ballot, jury, and ammo. Please use in that order." -Ed Howdershelt (Author) Genes Web page <http://geneslinuxbox.net:6309/gene> ------------------------------------------------------------------------------ Check out the vibrant tech community on one of the world's most engaging tech sites, Slashdot.org! http://sdm.link/slashdot _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users
