No I didn't. Nice. I just used a step/servo on a project last spring. I was amazed at how well it worked with a hires encoder connected. OTOH, it was over $700 but then raising a mast with equipment on it that cost way more.
BTW, does anyone know if LinuxCNC uses more than one core if it's a dual core processor? Or is the Real Time Varient restricted to only one core? Thanks John > -----Original Message----- > From: andy pugh [mailto:bodge...@gmail.com] > Sent: October-18-17 9:58 AM > To: Enhanced Machine Controller (EMC) > Subject: Re: [Emc-users] PC MB for Linux. > > On 18 October 2017 at 17:39, John Dammeyer <jo...@autoartisans.com> > wrote: > > Are you aware that you are not so very far from Canada's own servo company? > > www.dmm-tech.com > > > -- > atp > "A motorcycle is a bicycle with a pandemonium attachment and is > designed for the especial use of mechanical geniuses, daredevils and > lunatics." > � George Fitch, Atlanta Constitution Newspaper, 1916 > > ------------------------------------------------------------------------------ > Check out the vibrant tech community on one of the world's most > engaging tech sites, Slashdot.org! http://sdm.link/slashdot > _______________________________________________ > Emc-users mailing list > Emc-users@lists.sourceforge.net > https://lists.sourceforge.net/lists/listinfo/emc-users ------------------------------------------------------------------------------ Check out the vibrant tech community on one of the world's most engaging tech sites, Slashdot.org! http://sdm.link/slashdot _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users
