> The lights do not turn on the switch port that your Ethercat device is > plugged into?
Yes I tried both ports and soldered the EEPROM. Software in micro controller is not an issue because SPI port is not turned on until configured by the EEPROM. I will give up Twincat since I should not use it and continue with Ethercat master for linuxcnc which I should use. It feels a little bit odd LAN9252 need to be configured via network before it could communicate with micro controller via SPI. > Did you install TwinCat 2 or TwinCat 3. I have TwinCat 3 loaded on a > laptop here. I used Twincat3 but have no idea what it does to scan the network and then connected to switch Wireshark do no spot any Ethercat packets. Regards Nicklas Karlsson ------------------------------------------------------------------------------ Check out the vibrant tech community on one of the world's most engaging tech sites, Slashdot.org! http://sdm.link/slashdot _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
