On 01/18/2018 12:08 PM, tom-...@bgp.nu wrote:

... snip

Why is his code only good for 60 degree threads?

I think you can use whatever cross slide angle you what. Based on the tool link, maybe 29 / 2 = 14.4? You can also play with the depth of cut for each pass.


--
Kirk Wallace
http://www.wallacecompany.com/machine_shop/
http://www.wallacecompany.com/E45/

------------------------------------------------------------------------------
Check out the vibrant tech community on one of the world's most
engaging tech sites, Slashdot.org! http://sdm.link/slashdot
_______________________________________________
Emc-users mailing list
Emc-users@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/emc-users

Reply via email to