On 17 January 2018 at 01:16, <tom-...@bgp.nu> wrote:
>
> It seems like the Drive Line is where the tool should come back to on
> every pass.  If it did it would always have clearance (assuming it had
> clearance to get in the hole in the first place).  But that is not what is
> happening. From the GCode reference of G76:
> http://linuxcnc.org/docs/html/gcode/g-code.html#gcode:g76


 I think that only the full-depth retract is on the drive-line and each
other pass has the same retract distance as that last pass.
I imagine that this is to make every retract move exactly the same to
prevent any potential problems in the run-out area.

You should be able to carve your own G76 cycle using a sequence of G33
moves, possibly even as a remap. (G76.1?)

-- 
atp
"A motorcycle is a bicycle with a pandemonium attachment and is designed
for the especial use of mechanical geniuses, daredevils and lunatics."
— George Fitch, Atlanta Constitution Newspaper, 1916
------------------------------------------------------------------------------
Check out the vibrant tech community on one of the world's most
engaging tech sites, Slashdot.org! http://sdm.link/slashdot
_______________________________________________
Emc-users mailing list
Emc-users@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/emc-users

Reply via email to