> On Jan 17, 2018, at 10:43 AM, Kirk Wallace <kwall...@wallacecompany.com> > wrote: >> > I did a rewrite a while back: >> http://wallacecompany.com/tmp/G76/G76-7b.cc >> <http://wallacecompany.com/tmp/G76/G76-7b.cc> >> http://wallacecompany.com/tmp/G76/Screenshot-g76_kw-1a.png >> <http://wallacecompany.com/tmp/G76/Screenshot-g76_kw-1a.png> > This might not be fully debugged. > > This still has a retract hazard with some end taper settings: >> http://wallacecompany.com/t_tmp/G76_doc/g76_tool_clear.png >> <http://wallacecompany.com/t_tmp/G76_doc/g76_tool_clear.png> > > The original drive line shifts with each pass. The direction of I doesn't > match the documentation. This should affect diam/radius rather than behave > like mill space.
This is interesting. In your re-write, is the drive line set by the X position before the first move, or is it related to the I parameter (and how)? I would like to test this, what is the best way to install it? -Tom ------------------------------------------------------------------------------ Check out the vibrant tech community on one of the world's most engaging tech sites, Slashdot.org! http://sdm.link/slashdot _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users
