On Thu, May 24, 2018, 00:33 Ralph Stirling <[email protected]> wrote:
> I like to use Machine -> "Show Hal Configuration", which lets you see > and set any pin, and watch pins or signals. More convenient > than halmeters in my opinion. Halscope has a bit of a learning > curve. > This was excellent advice thank you > > -- Ralph > ________________________________________ > From: jeremy youngs [[email protected]] > Sent: Wednesday, May 23, 2018 8:48 PM > To: Enhanced Machine Controller (EMC) > Subject: Re: [Emc-users] 7i90 not listed in pnc > > Halmeter has blanked fields and inoperable buttons, so I cannot select > pins. > Halscope shows no active threads. So I cannot continue as the Hal tutorial > shows. > nothread.jpg > < > https://drive.google.com/file/d/1XgtzQuH2P6SGm6Y0BNHVGNNi9EBKvXLi/view?usp=drivesdk > > > > ------------------------------------------------------------------------------ > Check out the vibrant tech community on one of the world's most > engaging tech sites, Slashdot.org! http://sdm.link/slashdot > _______________________________________________ > Emc-users mailing list > [email protected] > https://lists.sourceforge.net/lists/listinfo/emc-users > > > ------------------------------------------------------------------------------ > Check out the vibrant tech community on one of the world's most > engaging tech sites, Slashdot.org! http://sdm.link/slashdot > _______________________________________________ > Emc-users mailing list > [email protected] > https://lists.sourceforge.net/lists/listinfo/emc-users > ------------------------------------------------------------------------------ Check out the vibrant tech community on one of the world's most engaging tech sites, Slashdot.org! http://sdm.link/slashdot _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
