My guess is that whatever signal you are sending to adaptive feed isn't actually going to 0...
On Mon, May 6, 2019, 9:56 AM a k <pccncmach...@gmail.com> wrote: > Hi > i use m52, to stop and slow down cnc. > M52 part of the program (main part). > already few people did tune up parameters to m52, and it start work > better-- STOP any motion of cnc, but at the best i can see that cnc move > 0.001 per 3 seconds. > if i need to stop for 5 minutes it be 0.01 total motion. > if programmed feed be 2 " /min in compare to 100" /min , same tune up for > M52 will have different result for creeping. > y/n? > i think it be good to ad self adjustable loop. > where system will see if it move and how fast / hove much it move and base > on that adjust -increase/decrease parameters for M52. > > thanks > aram > > _______________________________________________ > Emc-users mailing list > Emc-users@lists.sourceforge.net > https://lists.sourceforge.net/lists/listinfo/emc-users > _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users
