Yes, we try to tune up, parameters for m52 , and it is slow down motion but not to zero. ---- 0.001 for 3 sekonds .
On Mon, May 6, 2019, 8:03 AM Sam Sokolik <samco...@gmail.com> wrote: > My guess is that whatever signal you are sending to adaptive feed isn't > actually going to 0... > > On Mon, May 6, 2019, 9:56 AM a k <pccncmach...@gmail.com> wrote: > > > Hi > > i use m52, to stop and slow down cnc. > > M52 part of the program (main part). > > already few people did tune up parameters to m52, and it start work > > better-- STOP any motion of cnc, but at the best i can see that cnc move > > 0.001 per 3 seconds. > > if i need to stop for 5 minutes it be 0.01 total motion. > > if programmed feed be 2 " /min in compare to 100" /min , same tune up for > > M52 will have different result for creeping. > > y/n? > > i think it be good to ad self adjustable loop. > > where system will see if it move and how fast / hove much it move and > base > > on that adjust -increase/decrease parameters for M52. > > > > thanks > > aram > > > > _______________________________________________ > > Emc-users mailing list > > Emc-users@lists.sourceforge.net > > https://lists.sourceforge.net/lists/listinfo/emc-users > > > > _______________________________________________ > Emc-users mailing list > Emc-users@lists.sourceforge.net > https://lists.sourceforge.net/lists/listinfo/emc-users > _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users
