> From: Gregg Eshelman via Emc-users [mailto:emc- > Looks like your printer has some bad Z wobble, if the walls of the box are > supposed to be flat. > It's a very cheap 3D printer. The higher up the Z the more vibration movement in X and Y. Two others who had the same printer added an upper support frame. Eventually I'll get around to that. But for now, it's like my table saw or band saw. I walk up to it, I turn it on, I use it.
Even my friends who have since bought printers that cost 4x as much don't make prints that are that much better. I have low expectations from 3D printint. John > On Tuesday, November 26, 2019, 10:42:24 PM MST, John Dammeyer > <[email protected]> wrote: > I have 3D printed gears before.� Just not used them yet.� This structure > uses skate bearings but I never bothered making shafts but the pencils were > a close fit.� It spins very freely. > _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
