> On Sun, 21 Jun 2020 at 16:11, N <[email protected]> wrote: > > > > > Looking closer on chuck and slit, to long and wrong shape. Neither of them > > fit with tool changer. I tried ISO40 (DIN2080) so now is the question if I > > should try BT40 (JIS B6339) or SK40 (DIN69871) or both. > > > There is a risk of damaging the petal clamp if a pull-stud of the wrong > angle is used. I think you need to take the washer stack and petal clamp > out see what you have. > > But one alternative might be to form modelling clay around a stick on the > end of a holder with no pull stud, to see what shape it pushes the clay in > to. > > (And then when the clay gets stuck in the petals you have no choice but to > strip it all down for inspection) > > It might be easy. On my home-made drawbar the entire thing just lifts out: > https://youtu.be/pxrzJ_KfcQ0?t=23
This one is hydaulic with some kind of spring, was told by someone else here it is a belleville stack. Started a try to remove from bottom but changed my mind then I look at tool changer and discovered it did not fit in tool changer. Regards Nicklas Karlsson _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
