Thanks, I will remove first and try to check carefully. > The belleville stack will almost certainly remove out the top. > Some machines have two different width keys. The taper adapters will only > orient in a single direction. > Andy is correct! You MUST have the correct retention knob. There are a > million different knobs to choose from. Be very careful. > > On Sun, Jun 21, 2020, 12:32 PM N <nicklas.karlsso...@gmail.com> wrote: > > > > On Sun, 21 Jun 2020 at 16:11, N <nicklas.karlsso...@gmail.com> wrote: > > > > > > > > > > > Looking closer on chuck and slit, to long and wrong shape. Neither of > > them > > > > fit with tool changer. I tried ISO40 (DIN2080) so now is the question > > if I > > > > should try BT40 (JIS B6339) or SK40 (DIN69871) or both. > > > > > > > > > There is a risk of damaging the petal clamp if a pull-stud of the wrong > > > angle is used. I think you need to take the washer stack and petal clamp > > > out see what you have. > > > > > > But one alternative might be to form modelling clay around a stick on the > > > end of a holder with no pull stud, to see what shape it pushes the clay > > in > > > to. > > > > > > (And then when the clay gets stuck in the petals you have no choice but > > to > > > strip it all down for inspection) > > > > > > It might be easy. On my home-made drawbar the entire thing just lifts > > out: > > > https://youtu.be/pxrzJ_KfcQ0?t=23 > > > > This one is hydaulic with some kind of spring, was told by someone else > > here it is a belleville stack. Started a try to remove from bottom but > > changed my mind then I look at tool changer and discovered it did not fit > > in tool changer. > > > > > > Regards Nicklas Karlsson > > > > > > _______________________________________________ > > Emc-users mailing list > > Emc-users@lists.sourceforge.net > > https://lists.sourceforge.net/lists/listinfo/emc-users > > > > _______________________________________________ > Emc-users mailing list > Emc-users@lists.sourceforge.net > https://lists.sourceforge.net/lists/listinfo/emc-users
_______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users
