Hey guys. I bought the vertical machining centre! Bringing it home tomorrow then into the retro hopefully.
Here are some photos https://photos.app.goo.gl/Qdf89ubgfqixenaH8 Regards Andrew On Sun, Jun 7, 2020, 4:54 AM Jon Elson <el...@pico-systems.com> wrote: > On 06/06/2020 06:47 AM, andrew beck wrote: > > hey andy > > > > my motor feedback type is a fanuc incremental encoder. i think it is a > sin > > cos. > If this is the 10S motor you are talking about, it has > traditional differential TTL quadrature plus index, plus 4 > commutation signals that repeat 4 times per revolution. > Yes, it is an 8-pole motor. > > I did go throught it and checked that it was not a serial encoder a > > couple of months ago but I wil try dig the info out later I think it is > > 2048ppr > No, the 10S is not available with 2048 pulses. Your choices > are 1000, 2000, 2500, 3000 and 10,000. > > > Jon > > > _______________________________________________ > Emc-users mailing list > Emc-users@lists.sourceforge.net > https://lists.sourceforge.net/lists/listinfo/emc-users > _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users