On Thursday 10 September 2020 20:04:38 Gene Heskett wrote: > On Thursday 10 September 2020 19:53:16 andy pugh wrote: > > On Thu, 10 Sep 2020 at 22:46, Gene Heskett <ghesk...@shentel.net> > > wrote: > > > True but subject to the time granularity of the servo-loop, and > > > not fast enough to catch the first step without thinking about > > > addf ordering. > > > > The step-gen won't make steps until it sees the new target. So > > running the step-gen servo-thread section first in the list will > > mean that it always gets a 1mS (or so) wait before the first pulse. > > I'll try to remember that when I get ready to put it online. At my > current progress with this 3d printer, I may even be another year > older by then. :-(
That 4 lines of hal seems to be working, now I just need to find an output not currently occupied. If thats upside down, I assume a not right under it in the addf list would fix that. From the data sheet, I need to src a logic 1. Its a 100k load so driving both with one wire is feasible. Thank you guys. Cheers, Gene Heskett -- "There are four boxes to be used in defense of liberty: soap, ballot, jury, and ammo. Please use in that order." -Ed Howdershelt (Author) If we desire respect for the law, we must first make the law respectable. - Louis D. Brandeis Genes Web page <http://geneslinuxbox.net:6309/gene> _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users
