On 12/05/2020 11:41 PM, John Dammeyer wrote:
What I was wondering is if LinuxCNC, with a suitable Servo Motor or high res
encoder on the spindle can treat it like a 4th axis on a mill.
I believe some people have done this. One of the issues is
how to gracefully change LinuxCNC from a spindle mode to a C
axis mode, and back again. I suspect there could be a
little bit of HAL code using the MUX component that would
change connections appropriately.
Jon
_______________________________________________
Emc-users mailing list
Emc-users@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/emc-users
