On Thu, 14 Apr 2022, Marius wrote:
Date: Thu, 14 Apr 2022 16:18:43 +0200
From: Marius <mar...@mastercut.co.za>
Reply-To: "Enhanced Machine Controller (EMC)"
<emc-users@lists.sourceforge.net>
To: "Enhanced Machine Controller (EMC)" <emc-users@lists.sourceforge.net>
Subject: Re: [Emc-users] Looking for 7i92 bit file
Correct. It's not an issue. Just noted it. I looked at the source and it
does not assign a stepgen to the 16/17 pins of port 2. I might want to
change that for the next conversion where the Z axis will be used.
Did you setup the slave axis as X2?
It does but it deliberately sets it to stepgen 8 so it can be disabled
if use for spinel control on a 5ABOB breakout
I did set it up as X2. The INI and HAL also show that but I dont get
signal at the pin. I checked with the scope.
Probably a hal issue, I would check the hal file stepgen connections
I checked the hal, it's automagically generated. Not much I can screw up
there. It looks like it is not getting command or the pins are not
assigned
If thats the case, that is most likely a hal error. I would trace
the X2 position command with halshow.
Peter Wallace
Mesa Electronics
_______________________________________________
Emc-users mailing list
Emc-users@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/emc-users
