Sam and Robin, I found the immediate problem. The address should have been 10.10.10.10 rather than 10.10.10.11.
I have a CNC’d Grizzly G4000 that is running a 5i25 with a 7i76. I tried wiring the 7i76e the same as 7i76. LinuxCNC fires up now but none of the motors spin. However, the motor all hold. Thanks, Alan > > From: Sam Sokolik <samco...@gmail.com> > can you ping 10.10.10.10? > > On Sun, Sep 18, 2022 at 10:13 AM Alan Condit <condit.a...@gmail.com> > wrote: > > > I am trying to get my Raspberry Pi4 working with my 7i76e. I have the ip > > address set to 10.10.10.11 and number W3 set up. I generated a report. > > Maybe it is just not finding the 7i76e board. Can anyone give me a clue? > > > > Thanks, > > Alan > > > > <https://pastebin.com/Vm88mMY5 <https://pastebin.com/Vm88mMY5>> > > linuxcnc.report > > <https://pastebin.com/ke8YBWJ9 <https://pastebin.com/ke8YBWJ9>> > > myPCBMill.hal > > <https://pastebin.com/1ReQZSUw <https://pastebin.com/1ReQZSUw>> > > myPCBMill.ini > > _______________________________________________ > > Emc-users mailing list > > Emc-users@lists.sourceforge.net > > https://lists.sourceforge.net/lists/listinfo/emc-users > > > > > > > ---------- Forwarded message ---------- > From: Robin Szemeti <ro...@redpoint.org.uk> > To: "Enhanced Machine Controller (EMC)" <emc-users@lists.sourceforge.net> > Cc: > Bcc: > Date: Sun, 18 Sep 2022 16:15:40 +0100 > Subject: Re: [Emc-users] 7i76e with Rpi4 > That's what I have ... I have it wired directly to the ethernet port on the > Pi, I just used a normal cable, Note that when LinuxEMC takes over control > of the port, you can't use it for internet/IP connectivity (or at least I > can't) so you'll need some other interface in addition to that if you need > to connect to a network. I did try it through the usual router, but with > no success, so I just wired it direct. _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users
