I think I have all of my connections correct now. I had the wires for my probe switched with the X-axis limit switch. I took out the wiring for the drive enable, since it defaults to enabled. I can put that back after I get it running (if I want).
However, it appears that I have a more serious problem. I don’t seem to have any output voltage from my Meanwell SE-600-48 power supply. The fan was working so I assumed everything was fine, bad assumption on my end. Is it worth trying to repair, or should I just replace it? Alan From: "Peter C. Wallace" <p...@mesanet.com> > To: "Enhanced Machine Controller (EMC)" <emc-users@lists.sourceforge.net> > Cc: > Bcc: > Date: Tue, 20 Sep 2022 10:24:32 -0700 (PDT) > Subject: Re: [Emc-users] 7i76e with Rpi4 > On Tue, 20 Sep 2022, Alan Condit wrote: > > > Date: Tue, 20 Sep 2022 12:06:50 -0500 > > From: Alan Condit <condit.a...@gmail.com> > > Reply-To: "Enhanced Machine Controller (EMC)" > > <emc-users@lists.sourceforge.net> > > To: EMC-Users <emc-users@lists.sourceforge.net> > > Subject: Re: [Emc-users] 7i76e with Rpi4 > > > > I think I may be confused in Pncconf with the settings differences > between the 5i25/7i76 and the 7i76e. > > I am not getting any step/dir output on the TB2 connections. I chose > Connector 1 in Pncconf. Is that the correct place to set the STEP/DIR stuff > for TB2?? > > > > > The Step/Dir connections on the 7I76 and 7I76E are identical > > Peter Wallace > Mesa Electronics _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users
