Oops. https://youtu.be/tn1n2XQ3VIo
> -----Original Message----- > From: John Dammeyer [mailto:jo...@autoartisans.com] > Sent: January 11, 2025 5:18 PM > To: 'Enhanced Machine Controller (EMC)' > Subject: Re: [Emc-users] Automatic Probing. > > Thanks Andy, > I'll try that. Just finished reworking these heat sinks to have slightly deeper > pockets to clear the capacitors on the PC board. > > tps://youtu.be/tn1n2XQ3VIo > > One day I must really change the spindle drive so it doesn't rattle on the splines > and changed to a toothed belt. The motor pulley that I cast and machined is a > hair too large for the motor shaft and so has the slightest wobble. The closed > loop from the spindle encoder with non-symmetrical teeth and the wobbly > motor pulley seems to make the LinuxCNC spindle closed loop speed not great > at 2950 RPM. Barely gets up to speed and then oscillates around the set point. > > All things considered at least I got the job done. > John > > > -----Original Message----- > > From: Andy Pugh [mailto:bodge...@gmail.com] > > Sent: January 11, 2025 3:27 PM > > To: Enhanced Machine Controller > > Cc: Enhanced Machine Controller > > Subject: Re: [Emc-users] Automatic Probing. > > > > > > > > > On 11 Jan 2025, at 23:17, John Dammeyer <jo...@autoartisans.com> > > wrote: > > > > > > Must go through the whole process again of measuring the length of > > > the > > probe, etc. I can't use the tool setter to measure the probe length > because the > > probe trips before the tool setter does. > > > > Measure a tool with the tool setter, then machine a surface and probe > > the surface. > > > > You may want to set the probe length to zero in the table and set the > > tool relative to that. > > > > _______________________________________________ > > Emc-users mailing list > > Emc-users@lists.sourceforge.net > > https://lists.sourceforge.net/lists/listinfo/emc-users _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users
