I wasn't going to mention that... lol (I think the K&T has a motherboard with isa slots still - and I have a box of them 'just in case')
On Fri, Mar 28, 2025 at 9:54 AM Peter Wallace <[email protected]> wrote: > On Fri, 28 Mar 2025, Sam Sokolik wrote: > > > Date: Fri, 28 Mar 2025 09:42:07 -0500 > > From: Sam Sokolik <[email protected]> > > Reply-To: "Enhanced Machine Controller (EMC)" > > <[email protected]> > > To: "Enhanced Machine Controller (EMC)" <[email protected] > > > > > > It is still in the docs.. > > > > https://linuxcnc.org/docs/stable/html/drivers/servo-to-go.html > > It's still in the source... > > The real issue would be likely be finding a motherboard with a ISA slot > that can still run a recent enough version of Linux to host a non-ancient > version of LinuxCNC. > > (unless it's a PCI STG card) > > > > On Fri, Mar 28, 2025 at 9:25яяAM Dave Engvall <[email protected]> > wrote: > > > Is there any support for the stg card do I own an orphan? > > > > Dave > > > > > > _______________________________________________ > > Emc-users mailing list > > [email protected] > > https://lists.sourceforge.net/lists/listinfo/emc-users > > > > _______________________________________________ > Emc-users mailing list > [email protected] > https://lists.sourceforge.net/lists/listinfo/emc-users > > Peter Wallace > Mesa Electronics_______________________________________________ > Emc-users mailing list > [email protected] > https://lists.sourceforge.net/lists/listinfo/emc-users > _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
