----[Please read http://ercoupers.com/disclaimer.htm before following any advice in this forum.]----
Bob,
Don't cut holes. Remove the wings and look inside the center
section through the lightening holes.
Syd
[EMAIL PROTECTED] wrote:
>----[Please read http://ercoupers.com/disclaimer.htm before following any
advice in this forum.]----
>
>
>Does anyone know the proper tool to use to cut the 8 - 4" inspection
holes in the center section of the Ercoupe wing section that is required
by the current corrision AD. Also need a source of supply for any
recommended tool if possible. Any help would be apreciated.
>Bob Bullock
>N5621F Alon A2
>Maryland
>=========================================================================
=====
>To leave this forum go to: http://ercoupers.com/lists.htm
>Search the archives on http://escribe.com/aviation/coupers/
>
>
>
>
>.
>
>
>
==========================================================================
====
To leave this forum go to: http://ercoupers.com/lists.htm
Search the archives on http://escribe.com/aviation/coupers/
<<attachment: winmail.dat>>
