Lee. I am also agreeing with John here. The current setup of filters within the 
fuel system is sufficient as I know from my own experience. When I got my 
Ercoupe, I always !! had brownish sloshing particles floating in the tanks down 
to the gascolator. I flew the Coupe that way for around 500 hours. I cleaned 
out the gascolator before every flight and we cleaned the fuel pump on every 
annual as we should. On the following big overhaul, I took the carburetor apart 
and found little dirt in the bowl. A proof for me that the system works. As I 
understand the fuel system, the closer you get to the carburetor, the finer are 
the screen(s). The screen is protecting the unit behind the screen. So wing 
tank screens are sufficient to protect the fuel lines and the pump. The pump 
screen is efficient on filtering out stuff that could clog the gascolator and 
the gascolator is keeping all what is left.Then there is another screen on the 
entry to the carburetor.With this cascading order you are filtering out the 
bigger stuff first until down to the tiny garbage.Cleaning out all screens 
should be a task for the 100 hour inspection. Replacing the 'coarse metal 
screen' in the tanks will put all the filter action into the two sump locations 
and reduce the amount of filtering capacity of the system. I would be afraid 
that the filters might clog up and you are ending up where you did not want to 
be.   Hartmut


To: [EMAIL PROTECTED]: [EMAIL PROTECTED]: [EMAIL PROTECTED]: Thu, 25 Oct 2007 
11:42:09 +0000Subject: Re: [ercoupe-tech] Tank cleaning




Well guys and gals, I can only speak to what I know first hand.  4 planes that 
I have personal knowledge of have crashed due to fuel starvation that was 
precipitated by a brown substance that clogged the fuel system.  It would 
appear obvious that whatever we have now wasn't enough, so it seemed plausable 
to me that a filter that removes contaminates down to the micron (which are in 
autos that can pull off the road and stop should the engine stop) would be an 
acceptable solution.  The responses to this suggestion all have merit and give 
me pause to adding any filters and cause me to seek another method of removing 
contaminates before they cause a problem.  I am thinking that a close mesh 
nylon filter to replace the current coarse metal screen currently on the 
existing tanks would be abetter solution.  A long screen, perhaps 3" long would 
serve the same purpose and not add any restriction.  Bottom line is that I 
haven't had to land in any corn fields, lakes or trees and don't want to and I 
only know of one pilot that enjoyed such ventures.Lee-- [EMAIL PROTECTED] wrote:

 
I have to agree with John.  There are plenty of "filters" in the fuel system 
already.  If the tanks are sumped before every single flight like they are 
supposed to be, and if you don't get any dirt when you sump the tanks, then how 
could you possibly get enough dirt on any one screen to starve the engine of 
fuel?  If the tanks are sumped and there is consistently dirt, sloshing 
compound or some other stuff in the drained fuel, then the problem should be 
investigated and fixed.  Adding another fuel filter adds one more fuel system 
component and two more hose connections, all of which could cause problems of 
their own.  I sump my tanks before every single flight, regardless of how long 
ago the plane was last flown, or whether or not I refueled the airplane.  I 
occasionally get a little dirt or water out of the wing tanks, and every great 
once in a while I might get a drop or two of water out of the nose tank, but I 
virtually never get any water or dirt when I sump the gascolator, and the 
gascolator screen is perfectly clean and has been that way for over 2 years and 
330 flying hours since the plane was restored.  Adding a fuel filter isn't 
going to save someone who refuses to do a proper preflight inspection.   On a 
related subject, the times I do get a significant amount of water out of the 
tanks is after washing the airplane. My fuel tank caps are vented, and even 
though I completely tape up the entire fuel cap, I stll get water in the tanks 
when washing the plane.  Usually it takes several iterations of sumping the 
tanks, shaking the plane, waiting a few minutes and then sumping the tanks 
again to get all of the water out.  It is necessary to shake the plane between 
sumpings (is that a word?) because water will collect along the ribs in the 
tanks, and will stay there until the fuel sloshes it out of there.    Just my 
opinion.Wayne DelRossi-----Original Message-----From: John Cooper <[EMAIL 
PROTECTED]>To: [EMAIL PROTECTED]; [EMAIL PROTECTED]: Wed, 24 Oct 2007 9:48 
amSubject: RE: [ercoupe-tech] Tank cleaning






Lee, et al:
 
There is a screen in the fuel pump and another in the gascolator.  In addition, 
the carburetor has its own screen, and there are finger screens in the outlet 
fittings for all three tanks.  Adding another filter will only move the 
blockage to another point in the system.
 
 

John Cooper, A&P
Skyport Services
PO Box 249
4996 Delaware Tnpk
Rensselaerville, NY 12147
518 797-3064
Fax 518 797-3865
www.skyportservices.net 




From: [email protected] [mailto:[EMAIL PROTECTED] On Behalf Of 
[EMAIL PROTECTED]: Wednesday, October 24, 2007 6:25 AMTo: [EMAIL PROTECTED]: 
[EMAIL PROTECTED]: Re: [ercoupe-tech] Tank cleaning
 
Group, 
I am unfortunately aware of 4 Ervoupe crashes that have been caused by fuel 
starvation.  The starvation was the results of a brown material either causing 
the fuel pump to not provide fuel to the fuselage tank or blocking fuel flow to 
the carburetor.  It has been determined the brown material was the originally 
installed material know as sloshing compound.
It is a mystery to me that with all the precautions taken by FAA, why was a 
fuel filter not installed on the suction side of the fuel pump and between the 
fuselage tank and carburetor.  Unfortunately, I do not have a flying Ercoupe 
right now, but when and if I get another one, I will install filters in both 
locations and hopefully get approval with a 337.
Lee Browning-- "John W. Martin" <[EMAIL PROTECTED]> wrote:A good question.  
Here it is 60 plus years and still no filters. Isuppose they could be added 
with a 337?John"[EMAIL PROTECTED]" wrote:> John,>> I have never understood why 
there is no fuel filter between the> fuselage tank and carburetor and on the 
suction side of the fuel> pump.  That would have saved several lives and 
prevented more crashes.>> Lee>
_____________________________________________________________Click for free 
info on online degrees and make up to $150K/ year.



Email and AIM finally together. You've gotta check out free AOL Mail!
_____________________________________________________________Click here to save 
cash and find low rates on auto loans. 






_________________________________________________________________
Boo! Scare away worms, viruses and so much more! Try Windows Live OneCare!
http://onecare.live.com/standard/en-us/purchase/trial.aspx?s_cid=wl_hotmailnews

Reply via email to