Couldn't this be done by adjusting the cables? Kevin
--- In [email protected], [EMAIL PROTECTED] wrote: > > Hey Frank: To change the elevator rigging to 9 degrees requires moving the > stop on the control shaft about one inch to the rear. In order to get this done > properly, you must remove the control shafts from the plane and drill the > new stop hole by using a v block and a drill press. If your control wheels and > shafts have not been removed recently, I suspect that removing them will most > likely damage the taper pins holding them to the universal joints. Aside > from the taper pins, the only real problem is getting down under the instrument > panel to remove and replace those taper pins. > Lynn Nelsen > > > > ************************************** See what's new at http://www.aol.com >
