Hi Dave, The factory instructions for the lower speed warning cushion spring are in Ercoupe Service memorandum 35A. They want it adjusted for power off minimum airspeed of 60 mph. If flight testing reveals a speed of less than 60 mph, moving the spring into the next hole that would reduce the effective length raises that speed. They deem it OK to be a bit high, but not less than 60 mph.
So you will feel the spring resisting the yoke well before the stall at some speed above stall speed. Regards, WRB -- On Mar 17, 2010, at 23:18, [email protected] wrote: > Let me add that the low-speed warning spring bracket has three > positions that would allow the owner/operator and A&P to tailor the > onset of resistance to a lower, intermediate, or higher airspeed. I > don't know the spread, but it could only be a couple of degrees and a > couple of MPH. Since I've been flying a split-elevator 'coupe without > the spring and have added the spring during the restoration project, > I'm inclined to set it at the higher setting so the plane feels the > same as before until I'm just below stall speed. My thought are, > "flare up to the spring, pull through the spring to do a stall". > Anybody else have any knowledge of the optimum setting? > > Best, > Dave
