One thing I tried from an old A&P was to purchase some flouresent die put in the oil, run it and check for leaks using a black light. Really works. Need to change the oil after...
________________________________ From: "[email protected]" <[email protected]> To: [email protected] Sent: Tue, August 3, 2010 10:28:15 AM Subject: [ercoupe-tech] Oil leak from "blowby" Hey Mac: I am by no means an engine "expert", however, I have fixed a few oil leaks. The first thing is to clean the engine/compartment very thoroughly. Then run the engine one minute at a time examining very closely to determine where the oil is coming from. If you have lots of leaks, they may show up in the first or second minute. Once you determine where they are coming from, then you can determine the best process to stop the leak. Areas to consider (besides the push rod tubes) are front crankcase seal, fuel pump, cylinder seals, oil tank, oil tank filler cap, generator and starter, tach drive, crankcase joint, pump drive under crankcase (if your engine has the plate) and the crankcase vent tube. One item to check on the crankcase vent is that the extension has been added to the vent fitting. Your engine did not come with one. As you can see, there are a lot of areas that can cause oil leaks besides the cylinders (and possible high back pressure) and eliminating all of them should make it easier to decide if new cylinders are required. Another thing you might do is go to your local EAA chapter meeting and ask them who they recommend to stop oil leaks. Lynn Nelsen
