The EV bug that I've been working on had that $4000 EV conversion kit... and it's is entirely not suited for a car that heavy. I have to imagine that a Fiero is heavier than than a '73 VW bug. So far, I've added actual circuit breakers, a battery monitor, a proper battery charger, a cooling fan and heat sink on the controller, and got the point where I found that the marine deep cycle batteries cannot move a car that heavy for more than 5 or 6 miles before too much voltage sag sets in. Currently upgrading it to lithium batteries, but then I'm sure the motor will be the weakest link -- I was able to get close to overheating the motor on hills with the lead acid batteries, but they died before the motor overheated.... To do a roadgoing EV, you really need more like $10k it seems, unless you get a lot of used parts.
To made a roadgoing ICE, from scratch starting with a glider, with all new parts, would probably cost just as much, BTW. It's just that used parts for ICE's are much more available. Z On Mon, Mar 24, 2014 at 10:52 PM, brucedp5 <[email protected]> wrote: > [ref > > http://electric-vehicle-discussion-list.413529.n4.nabble.com/1986-Pontiac-Fiero-conversion-tp4668635.html > ] > > I sent an email to FieroNewbie letting them know that they mistakenly > subscribed to the evdl nabble archive and have not properly subscribed to > the evdl (their archive posts are not seen by members). I encouraged them > to > subscribe so that we could have a dialog. > > This type of thing happens regularly, so I have a sort-of form letter I > send > out. Most of the time, they get subscribed properly. Or when they try and > fail, I ask our beloved sys-admin David, to lend a hand. > > But FieroNewbie is either afk, has lost interest, or thrown their hands up > in frustration. Too bad, there are plenty of read hits, so there are evdl > members that would have liked to help them achieve the goals. > > Leaving a message like this, where one party is not subscribed so that > members can't talk to them, really does not work (they really need to get > subscribed properly). But allowing for different personalities, I will post > some points, and perhaps others will too. It may help FieroNewbie, we do > not > know (we can't talk to them). But, I hope this effort encourages them to > subscribe properly to the evdl.org , and get the free advice and EV > information from experienced EV converters/builders. > > > A conversion is not a cheap project, unless you were aiming to only make it > move at city street speeds for only a few miles (like a sub-highway speed > neighborhood EV, a nEV). I will assume that does not fit your EV driving > needs, and you really want an EV that can go 65mph, with a 30+ mile range, > and feel safe when mixing it up on the highway. That is going to cost money > (and so would fixing up the Fiero as an gas-car, an ice). > > Until FieroNewbie gets subscribed, I can suggest that they look at all the > configurations of Fiero's already converted on evalbum.com Using a search > gives: > https://www.google.com/search?q=evalbum+fiero > > Looking at their converted EVs gives the newbie an idea of what components > were used, and what performance those gave. Different system voltages, > controllers, motors, give different performances at different project > costs. > > BTW, when you do begin your EV conversion project, I suggest you grab a > free > evalbum page. Then you can reference to it's web page address, URL, in your > discussions (and future posts with your progress, etc.). Even if you do not > have any pictures yet, just put up the basics so others can know quickly > what is happening. Their web pages are very easy, and you do not need to be > a programmer to use them. > > Referencing back to trying to do this on the cheap, it might have been > wiser > to not have bought the donor, but buy a working but used/pre-owned EV > conversion. These can be still found, and at a good price. But you may have > to pay to have it hauled home (don't jsut search locally, search > nation-wide). > > If you do get subscribed properly, please post: > -where you are (a general idea, i.e.: in UT, etc.)? > > -what you want your EV to do (what top&cruising-speed, range@65mph, > charging-time& @what AC voltage, and at what total project cost)? > > -state how much mechanical experience you have, and is the work going to be > done in a location that can have the donor be dismantled for months+ ? > > > I hope you do get subscribed properly to the evdl.org , we would like to > help you. > > > Bruce {EVangel} Parmenter > brucedp.150m.com > (Near Silicon Valley, south of SF, CA USA) > > > > - > 1986 Pontiac Fiero conversion > Mar 24, 2014; 4:45pm -- by FieroNewbie > I picked up the Fiero for an EV conversion. It has a fiberglass body > that's > in good shape but needs a paint job. EV conversion is new to me and I was > about to purchase the whole conversion kit from a company in Utah that does > EV conversions but when people on the Internet got sticker shock at the > $4,000 price tag (I would also have to buy the lead acid batteries for at > least $900), they suggested that I purchase the components separately and > save a couple of thousand dollars. > > No one has been helpful in selecting the specific motor, the controller > (Paul & Sabrina's controller looks reasonable) and the other parts needed > for the conversion. Can anyone help me in selecting the components needed > for my project? > - > > > > -- > View this message in context: > http://electric-vehicle-discussion-list.413529.n4.nabble.com/1986-Pontiac-Fiero-conversion-tp4668635p4668636.html > Sent from the Electric Vehicle Discussion List mailing list archive at > Nabble.com. > _______________________________________________ > UNSUBSCRIBE: http://www.evdl.org/help/index.html#usub > http://lists.evdl.org/listinfo.cgi/ev-evdl.org > For EV drag racing discussion, please use NEDRA ( > http://groups.yahoo.com/group/NEDRA) > > -------------- next part -------------- An HTML attachment was scrubbed... URL: <http://lists.evdl.org/private.cgi/ev-evdl.org/attachments/20140325/68773689/attachment.htm> _______________________________________________ UNSUBSCRIBE: http://www.evdl.org/help/index.html#usub http://lists.evdl.org/listinfo.cgi/ev-evdl.org For EV drag racing discussion, please use NEDRA (http://groups.yahoo.com/group/NEDRA)
