Well, that isn’t the CU6 problem. Do you have an option for this particular window of looking at the generated PowerShell? Does it look normal?
From: [email protected] [mailto:[email protected]] On Behalf Of Candee Sent: Tuesday, September 2, 2014 3:49 PM To: [email protected] Subject: Re: [Exchange] Fwd: Exchange 2010 distro list Not at all - only when he tries adding /removing through the EMC. On Tue, Sep 2, 2014 at 3:40 PM, Michael B. Smith <[email protected]<mailto:[email protected]>> wrote: Does it happen in the EMS? From: [email protected]<mailto:[email protected]> [mailto:[email protected]<mailto:[email protected]>] On Behalf Of Candee Sent: Tuesday, September 2, 2014 3:29 PM To: [email protected]<mailto:[email protected]> Subject: Re: [Exchange] Fwd: Exchange 2010 distro list No; Outlook is pretty speedy. On Tue, Sep 2, 2014 at 3:14 PM, Michael B. Smith <[email protected]<mailto:[email protected]>> wrote: Does this problem occur also in Outlook? From: [email protected]<mailto:[email protected]> [mailto:[email protected]<mailto:[email protected]>] On Behalf Of Candee Sent: Tuesday, September 2, 2014 2:49 PM To: [email protected]<mailto:[email protected]> Subject: Re: [Exchange] Fwd: Exchange 2010 distro list Thanks Michael - the DCs shown are all local. I was hoping that was it! On Tue, Sep 2, 2014 at 2:01 PM, Michael B. Smith <[email protected]<mailto:[email protected]>> wrote: This sounds very similar to an Exchange 2013 problem that was just corrected in CU6, where Exchange would choose DCs in remote AD sites under certain circumstances. Does your Application event 2080 look correct? Are the DCs shown in "*** Servers Servers Servers ***" $r = Get-ExchangeServer -Status $r | fl Name, Site, ServerRole, AdminDisplayVersion, Static*, Current* The proper ones? From: [email protected]<mailto:[email protected]> [mailto:[email protected]<mailto:[email protected]>] On Behalf Of Candee Sent: Tuesday, September 2, 2014 1:43 PM To: [email protected]<mailto:[email protected]> Subject: [Exchange] Fwd: Exchange 2010 distro list Hi everyone; Exchange 2010, SP3, fully patched. The help desk just brought this to my attention, and I have done some testing. Using the EMC, trying to add/remove members from the distribution list "members" tab. If the distro list contains contacts, the members can take 5 or more minutes to load the OUs - nothing can be done until they are finished loading. If the distro list only contains mailboxes, the tab loads almost immediately. It doesn't matter what OU the contacts are in; whether they're brand new or established. There is nothing in the event viewers; and I can't find anything on the interwebs. Any ideas what else to check? Thanks! Candee
