Hi!
i did not change any settings in my bios since i installed mandrake...
in fact , this happened from the first boot after installation... :(
when running lilo i get :
[root@webug /root]# lilo
Warning: /dev/hdb is not on the first disk
Added linux *
Added failsafe
Added floppy
[root@webug /root]
my primary disk (as you can see) is not hda but hdd... i had some
problems installing
it as primary, so it's configured as secondary slave..
think that could be the reason ??
>>>>>>>>>>>>>>>>>> Original Message <<<<<<<<<<<<<<<<<<
On 6/16/00, 12:26:23 PM, "Juan A. Magallon" <[EMAIL PROTECTED]>
wrote regarding Re: [expert] lilo:
> At 02:35 +0000 2000/06/16, tal amir wrote:
> >Hey you guy's ! :-)
> >
> >when booting lilo (mdk 7.1) i am getting :
> >
> >li 04 04 04 04 04 04 04 04 04 04 04 04 04 04 04
> >04 04 04 04 04 04 04 04 04 04 04 04 04 04 04 04
> >04 04 04 04 04 04 04 04 04 04 04 04 04 04 04 04
> >04 04 04 04 04 04 04 04 04 04 04 04 04 04 04 04
> >04 04 04 04 04 04 04 04 04 04 04 04 04 04 04 04
> >04 04 04 04 04 04 04 04 04 04 04 04 04 04 04 04
> >
> Suffered from that sometimes: two possible causes:
> - You booted with some different BIOS setting for your hard drive when
> running lilo and when trying to boot with the kernel lilo
intalled
> (say you booted with disk in LBA mode, and then rebooted in
LARGE
> or NORMAL)
> - You changed kenel (usuallly /vmlinuz or /boot/vmlinuz) without
re-running
> lilo. Or you ran lilo and it didn't found the default kernel you
> specified in lilo.conf
> Take a look to the error messages when running lilo....
> Good Luck.
> --
> Juan Antonio Magallon Lacarta
mailto:[EMAIL PROTECTED]
> Grupo de Informatica Grafica Avanzada
http://giga.cps.unizar.es
> Tlf: 34-976-762354,1916 - Fax: 34-976-761914
