I did not check the specs for the modem so I do not know if it is a winmodem
or not.
Since it is a PCI modem it needs to be set as ttyS3 not ttyS2
Try the setserial commands using that parameter.
Charles (-:
Forever never goes beyond tomorrow.
> -----Original Message-----
> From: [EMAIL PROTECTED]
> [mailto:[EMAIL PROTECTED]]On Behalf Of Andrew Judge
> Sent: Saturday, January 20, 2001 11:32 AM
> To: Mandrake Expert
> Subject: [expert] USR 3CP5610A - Modem won't work
>
>
> I have the USR 3CP5610A modem on 7.2 and can't make it work.
> It shows up in
> hard drake, but when I try to configure it, hard drake stares
> that it can't
> configure a winmodem. This isn't a winmodem and I have tried
> the following
> based on my /proc/pci:
>
> <snip>
>
> Bus 0, device 9, function 0:
> Serial controller: Unknown vendor Unknown device (rev 1).
> Vendor id=12b9 Device id=1008
> Medium devsel. IRQ 9 I/O at 0xdc00 [0xdc01]
> </snip>
>
> setserial /dev/ttyS2 irq 9 port 0xdc00 autoconfig
>
> setserial /dev/ttyS2 irq 9 port 0xdc00 ^fourport ^auto_irq skip_test
> autoconfig spd_vhi
>
> Neither setserial commands work. Also, the IRQ appears to be
> unused by any
> other device. Can anyone point me in the right direction? Thxs.
>
> Andy Judge
>
>
>
>
>
