I use a USR 3CP5610A modem on 7.2 and it works fine. You will need to use
2.4.x kernel. I cant get it to work on 2.2.x kernel. USR also says this
modem requires 2.3.x kernel.
Joe
-----Original Message-----
From: Andrew Judge [mailto:[EMAIL PROTECTED]]
Sent: Saturday, January 20, 2001 11:32 AM
To: Mandrake Expert
Subject: [expert] USR 3CP5610A - Modem won't work
I have the USR 3CP5610A modem on 7.2 and can't make it work. It shows up in
hard drake, but when I try to configure it, hard drake stares that it can't
configure a winmodem. This isn't a winmodem and I have tried the following
based on my /proc/pci:
<snip>
Bus 0, device 9, function 0:
Serial controller: Unknown vendor Unknown device (rev 1).
Vendor id=12b9 Device id=1008
Medium devsel. IRQ 9 I/O at 0xdc00 [0xdc01]
</snip>
setserial /dev/ttyS2 irq 9 port 0xdc00 autoconfig
setserial /dev/ttyS2 irq 9 port 0xdc00 ^fourport ^auto_irq skip_test
autoconfig spd_vhi
Neither setserial commands work. Also, the IRQ appears to be unused by any
other device. Can anyone point me in the right direction? Thxs.
Andy Judge
