Clay,

I do not know if this is related to your problem, but I notice that even in 
PowerSDR 1.18.6, if I start the program with the NR button selected, I do not 
have audio until I adjust the AGC-T or (I believe) the AF button. I am not sure 
if this is still a problem in version 2.0 as I have not installed the beta 
version on this new computer.

Ed, K0KC





________________________________
From: Clay W7CE <[email protected]>
To: [email protected]
Sent: Sun, July 4, 2010 11:55:11 AM
Subject: [FlexEdge] PSDR 2.0.0 Dramatic Pause when switching between CW and SSB

When I first installed 2.0.0 (plus Flex Driver 3.5.3.028 and Firmware 2.0.2.2) 
on my 5000A, I did the recommended image calibration.  After a few days I 
noticed that I was seeing definite images in the Panadapter from strong 6M 
stations.  Yesterday I ran image calibration again for 6M only and noticed an 
immediate behavior change.  When I switch from SSB to CW, or vice versa, the 
Start button goes off momentarily, the radio changes modes and then the Start 
button is highlighted again.  During the off time (1/2 to 1 second), the audio 
stops.  Before the doing 6M image calibration it wasn't doing this and 
switching modes was instantaneous for all practical purposes. One time when I 
switched to CW the start button came back on but there was no audio.  I had to 
go back to SSB and try again to get it working.  I just shut everything off and 
rebooted the computer but the behavior is the same. It's not a show stopper, 
but it is annoying.  Has anyone else
 noticed this? Any ideas what might have happened?

73,
Clay  W7CE 

_______________________________________________
Flexedge mailing list
[email protected]
http://mail.flex-radio.biz/mailman/listinfo/flexedge_flex-radio.biz
This is the FlexRadio Systems e-mail Reflector called FlexEdge.  It is used for 
posting topics related to SDR software development and experimentalist who are 
using alpha and beta versions of the software.



      
_______________________________________________
Flexedge mailing list
[email protected]
http://mail.flex-radio.biz/mailman/listinfo/flexedge_flex-radio.biz
This is the FlexRadio Systems e-mail Reflector called FlexEdge.  It is used for 
posting topics related to SDR software development and experimentalist who are 
using alpha and beta versions of the software.

Reply via email to