Clay, I had the same experience, exactly.
Bob K5SM
On 7/4/2010 10:55 AM, Clay W7CE wrote:
When I first installed 2.0.0 (plus Flex Driver 3.5.3.028 and Firmware
2.0.2.2) on my 5000A, I did the recommended image calibration. After
a few days I noticed that I was seeing definite images in the
Panadapter from strong 6M stations. Yesterday I ran image calibration
again for 6M only and noticed an immediate behavior change. When I
switch from SSB to CW, or vice versa, the Start button goes off
momentarily, the radio changes modes and then the Start button is
highlighted again. During the off time (1/2 to 1 second), the audio
stops. Before the doing 6M image calibration it wasn't doing this and
switching modes was instantaneous for all practical purposes. One time
when I switched to CW the start button came back on but there was no
audio. I had to go back to SSB and try again to get it working. I
just shut everything off and rebooted the computer but the behavior is
the same. It's not a show stopper, but it is annoying. Has anyone
else noticed this? Any ideas what might have happened?
73,
Clay W7CE
_______________________________________________
Flexedge mailing list
[email protected]
http://mail.flex-radio.biz/mailman/listinfo/flexedge_flex-radio.biz
This is the FlexRadio Systems e-mail Reflector called FlexEdge. It is
used for posting topics related to SDR software development and
experimentalist who are using alpha and beta versions of the software.
--
73, Bob K5SM
_______________________________________________
Flexedge mailing list
[email protected]
http://mail.flex-radio.biz/mailman/listinfo/flexedge_flex-radio.biz
This is the FlexRadio Systems e-mail Reflector called FlexEdge. It is used for
posting topics related to SDR software development and experimentalist who are
using alpha and beta versions of the software.