Wide band image rejection (WBIR) is not working properly which is what you are 
seeing.  The bug has been reported.

-Tim
--------
Sent from my iPhone

On Jul 4, 2010, at 12:36 PM, "Robert Redmon" <[email protected]> wrote:

>  Clay, I had the same experience, exactly.
> 
> Bob K5SM
> 
> On 7/4/2010 10:55 AM, Clay W7CE wrote:
>> When I first installed 2.0.0 (plus Flex Driver 3.5.3.028 and Firmware 
>> 2.0.2.2) on my 5000A, I did the recommended image calibration.  After 
>> a few days I noticed that I was seeing definite images in the 
>> Panadapter from strong 6M stations.  Yesterday I ran image calibration 
>> again for 6M only and noticed an immediate behavior change.  When I 
>> switch from SSB to CW, or vice versa, the Start button goes off 
>> momentarily, the radio changes modes and then the Start button is 
>> highlighted again.  During the off time (1/2 to 1 second), the audio 
>> stops.  Before the doing 6M image calibration it wasn't doing this and 
>> switching modes was instantaneous for all practical purposes. One time 
>> when I switched to CW the start button came back on but there was no 
>> audio.  I had to go back to SSB and try again to get it working.  I 
>> just shut everything off and rebooted the computer but the behavior is 
>> the same. It's not a show stopper, but it is annoying.  Has anyone 
>> else noticed this? Any ideas what might have happened?
>> 
>> 73,
>> Clay  W7CE
>> 
>> _______________________________________________
>> Flexedge mailing list
>> [email protected]
>> http://mail.flex-radio.biz/mailman/listinfo/flexedge_flex-radio.biz
>> This is the FlexRadio Systems e-mail Reflector called FlexEdge.  It is 
>> used for posting topics related to SDR software development and 
>> experimentalist who are using alpha and beta versions of the software.
>> 
> 
> -- 
> 73, Bob K5SM
> 
> 
> _______________________________________________
> Flexedge mailing list
> [email protected]
> http://mail.flex-radio.biz/mailman/listinfo/flexedge_flex-radio.biz
> This is the FlexRadio Systems e-mail Reflector called FlexEdge.  It is used 
> for posting topics related to SDR software development and experimentalist 
> who are using alpha and beta versions of the software.

_______________________________________________
Flexedge mailing list
[email protected]
http://mail.flex-radio.biz/mailman/listinfo/flexedge_flex-radio.biz
This is the FlexRadio Systems e-mail Reflector called FlexEdge.  It is used for 
posting topics related to SDR software development and experimentalist who are 
using alpha and beta versions of the software.

Reply via email to