Is the WBIR problem causing the images or the delay when going from SSB to
CW (or both)? I understand the image problem, but am not sure how that
would cause such a long delay when switching modes. Especially since mode
changes were fine after doing an image calibration for all bands, but not
after doing the 2nd 6M only calibration.
----- Original Message -----
From: "Tim Ellison" <[email protected]>
To: "Robert Redmon" <[email protected]>
Cc: <[email protected]>
Sent: Sunday, July 04, 2010 10:01 AM
Subject: Re: [FlexEdge] PSDR 2.0.0 Dramatic Pause when switching between CW
and SSB
Wide band image rejection (WBIR) is not working properly which is what you
are seeing. The bug has been reported.
-Tim
--------
Sent from my iPhone
On Jul 4, 2010, at 12:36 PM, "Robert Redmon" <[email protected]> wrote:
Clay, I had the same experience, exactly.
Bob K5SM
On 7/4/2010 10:55 AM, Clay W7CE wrote:
When I first installed 2.0.0 (plus Flex Driver 3.5.3.028 and Firmware
2.0.2.2) on my 5000A, I did the recommended image calibration. After
a few days I noticed that I was seeing definite images in the
Panadapter from strong 6M stations. Yesterday I ran image calibration
again for 6M only and noticed an immediate behavior change. When I
switch from SSB to CW, or vice versa, the Start button goes off
momentarily, the radio changes modes and then the Start button is
highlighted again. During the off time (1/2 to 1 second), the audio
stops. Before the doing 6M image calibration it wasn't doing this and
switching modes was instantaneous for all practical purposes. One time
when I switched to CW the start button came back on but there was no
audio. I had to go back to SSB and try again to get it working. I
just shut everything off and rebooted the computer but the behavior is
the same. It's not a show stopper, but it is annoying. Has anyone
else noticed this? Any ideas what might have happened?
73,
Clay W7CE
_______________________________________________
Flexedge mailing list
[email protected]
http://mail.flex-radio.biz/mailman/listinfo/flexedge_flex-radio.biz
This is the FlexRadio Systems e-mail Reflector called FlexEdge. It is
used for posting topics related to SDR software development and
experimentalist who are using alpha and beta versions of the software.
--
73, Bob K5SM
_______________________________________________
Flexedge mailing list
[email protected]
http://mail.flex-radio.biz/mailman/listinfo/flexedge_flex-radio.biz
This is the FlexRadio Systems e-mail Reflector called FlexEdge. It is
used for posting topics related to SDR software development and
experimentalist who are using alpha and beta versions of the software.
_______________________________________________
Flexedge mailing list
[email protected]
http://mail.flex-radio.biz/mailman/listinfo/flexedge_flex-radio.biz
This is the FlexRadio Systems e-mail Reflector called FlexEdge. It is
used for posting topics related to SDR software development and
experimentalist who are using alpha and beta versions of the software.
_______________________________________________
Flexedge mailing list
[email protected]
http://mail.flex-radio.biz/mailman/listinfo/flexedge_flex-radio.biz
This is the FlexRadio Systems e-mail Reflector called FlexEdge. It is used for
posting topics related to SDR software development and experimentalist who are
using alpha and beta versions of the software.