Vic
Currently you cannot send RX1 down one VAC and RX2 down another. Dont know when its due to be done . To output RX1 and RX2 on to separate stereo channels Right next to the MultiRX button there is a slider -- slide that all the way left to send RX1 to left channel. To the right of the RX2 button is a slider labeled Pan slide that all the way right and RX2 will go through the right channel. Dave W0DHB -----Original Message----- From: [email protected] [mailto:[email protected]] On Behalf Of k4xtt Sent: Wednesday, December 29, 2010 3:59 PM To: [email protected] Subject: [FlexEdge] VAC and PSDR Could someone give a straight answer as to whether it's possible for the 2nd receiver of the 5000A to be programmed to use VAC (with separate cables from the main receiver) and if it is, when? A major part of using a second receiver would be to run programs connected to it, like some other radios can do. Basically two radios in one, which is what I thought the Flex advertisements suggested. Then again maybe I misinterpreted and hoped for too much. Also there is the suggestion of breaking out the audio from each receiver ported to the stereo jack on the back of the Flex 5000A. As in right and left channels. I have not been able to get this to work. In fact I cannot get any audio from that jack. Any suggestions as to what I'm doing incorrectly, or again am I misinterpreting it's use. Thanks, Vic K4XTT _______________________________________________ Flexedge mailing list [email protected] http://mail.flex-radio.biz/mailman/listinfo/flexedge_flex-radio.biz This is the FlexRadio Systems e-mail Reflector called FlexEdge. It is used for posting topics related to SDR software development and experimentalist who are using beta versions of the software. _______________________________________________ Flexedge mailing list [email protected] http://mail.flex-radio.biz/mailman/listinfo/flexedge_flex-radio.biz This is the FlexRadio Systems e-mail Reflector called FlexEdge. It is used for posting topics related to SDR software development and experimentalist who are using beta versions of the software.
