Okay Tim, thanks for the clarification. I know it can be hard to
redirect a projects goals when the "Building is almost done" A lot of
time involved that can be best used on a new design or bugs. (deep impact)
The sooner Deep Impact gets started the better for all. Just my view.
I'll bet that the Flex projects designers and implementors may have not
foreseen how this practical use of a "concept" has impacted radio
today. I hear a ton of positive discussion on the bands. My hat's off
to all, despite my impatience.
Thanks, and Happy New Year.
Vic
On 12/29/2010 7:36 PM, Tim Ellison wrote:
The limitation is the audio/IQ routing architecture in PowerSDR. It was never
designed from the beginning to support multiple hardware receivers (it was
built for the SDR-1000).
It would be very difficult at this juncture to "retool" PowerSDR to do this.
The feature will have to wait until Deep Impact.
-Tim
-----Original Message-----
From: [email protected] [mailto:[email protected]]
On Behalf Of k4xtt
Sent: Wednesday, December 29, 2010 7:07 PM
To: [email protected]
Subject: Re: [FlexEdge] VAC and PSDR
Okay, what is the limiting parameter? Just programing or some hardware issue?
If it's in any way related to hardware, I'll be looking for other solutions.
Thanks,
Vic
On 12/29/2010 6:23 PM, Jerry Flanders wrote:
I think VAC is not possible at present.
To get audio from the rca jack on the rear: MIXER - OUTPUT - check:
Line Out RCA
Jerry W4UK
At 05:58 PM 12/29/2010, k4xtt wrote:
Could someone give a straight answer as to whether it's possible for
the 2nd receiver of the 5000A to be programmed to use VAC (with
separate cables from the main receiver) and if it is, when? A major
part of using a second receiver would be to run programs connected to
it, like some other radios can do. Basically two radios in one, which
is what I thought the Flex advertisements suggested. Then again
maybe I misinterpreted and hoped for too much.
Also there is the suggestion of breaking out the audio from each
receiver ported to the stereo jack on the back of the Flex 5000A. As
in right and left channels. I have not been able to get this to
work. In fact I cannot get any audio from that jack. Any
suggestions as to what I'm doing incorrectly, or again am I
misinterpreting it's use.
Thanks, Vic K4XTT
_______________________________________________
Flexedge mailing list
[email protected]
http://mail.flex-radio.biz/mailman/listinfo/flexedge_flex-radio.biz
This is the FlexRadio Systems e-mail Reflector called FlexEdge. It is used for
posting topics related to SDR software development and experimentalist who are
using beta versions of the software.
_______________________________________________
Flexedge mailing list
[email protected]
http://mail.flex-radio.biz/mailman/listinfo/flexedge_flex-radio.biz
This is the FlexRadio Systems e-mail Reflector called FlexEdge. It is used for
posting topics related to SDR software development and experimentalist who are
using beta versions of the software.
