The limitation is the audio/IQ routing architecture in PowerSDR. It was never designed from the beginning to support multiple hardware receivers (it was built for the SDR-1000).
It would be very difficult at this juncture to "retool" PowerSDR to do this. The feature will have to wait until Deep Impact. -Tim -----Original Message----- From: [email protected] [mailto:[email protected]] On Behalf Of k4xtt Sent: Wednesday, December 29, 2010 7:07 PM To: [email protected] Subject: Re: [FlexEdge] VAC and PSDR Okay, what is the limiting parameter? Just programing or some hardware issue? If it's in any way related to hardware, I'll be looking for other solutions. Thanks, Vic On 12/29/2010 6:23 PM, Jerry Flanders wrote: > I think VAC is not possible at present. > > To get audio from the rca jack on the rear: MIXER - OUTPUT - check: > Line Out RCA > > Jerry W4UK > > At 05:58 PM 12/29/2010, k4xtt wrote: >> Could someone give a straight answer as to whether it's possible for >> the 2nd receiver of the 5000A to be programmed to use VAC (with >> separate cables from the main receiver) and if it is, when? A major >> part of using a second receiver would be to run programs connected to >> it, like some other radios can do. Basically two radios in one, which >> is what I thought the Flex advertisements suggested. Then again >> maybe I misinterpreted and hoped for too much. >> >> Also there is the suggestion of breaking out the audio from each >> receiver ported to the stereo jack on the back of the Flex 5000A. As >> in right and left channels. I have not been able to get this to >> work. In fact I cannot get any audio from that jack. Any >> suggestions as to what I'm doing incorrectly, or again am I >> misinterpreting it's use. >> >> Thanks, Vic K4XTT > > _______________________________________________ Flexedge mailing list [email protected] http://mail.flex-radio.biz/mailman/listinfo/flexedge_flex-radio.biz This is the FlexRadio Systems e-mail Reflector called FlexEdge. It is used for posting topics related to SDR software development and experimentalist who are using beta versions of the software. _______________________________________________ Flexedge mailing list [email protected] http://mail.flex-radio.biz/mailman/listinfo/flexedge_flex-radio.biz This is the FlexRadio Systems e-mail Reflector called FlexEdge. It is used for posting topics related to SDR software development and experimentalist who are using beta versions of the software.
