where is your zero reference point. If outside the pcb area you might see
this error ??
-----Original Message-----
From: Jim Muehlberg [mailto:[EMAIL PROTECTED]]
Sent: Thursday, May 17, 2001 12:22 PM
To: Protel Forum
Subject: [PEDA] Board Size - Conflict
My PCB is (or so I thought it was) 10000 X 6500 mils as indicated on the
mechanical layer. BUT, when I go to reports|board information-general,
is says 10360 x 6785.987 mils.
What gives?
--
Jim Muehlberg
Electrical Engineer
LO/IF Group
National Radio Astronomy Observatory
P.O. Box O
1003 Lopezville Rd.
Socorro, NM 87801
P: 505-835-7140/7195
F: 505-835-7027
http://www.aoc.nrao.edu/~jmuehlbe
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* To post a message: mailto:[EMAIL PROTECTED]
*
* To leave this list visit:
* http://www.techservinc.com/protelusers/subscrib.html
* - or email -
* mailto:[EMAIL PROTECTED]?body=leave%20proteledaforum
*
* Contact the list manager:
* mailto:[EMAIL PROTECTED]
*
* Browse or Search previous postings:
* http://www.mail-archive.com/[email protected]
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
